2008 Chevy Silverado Engine Specs
Engine Configuration
The 2008 Chevy Silverado offers several engine options, each designed to provide power and performance for various driving needs. Here are the engine configurations available for this model:
1. 4.3L V6 Engine:
– Displacement: 4.3 liters
– Number of cylinders: 6
– Horsepower: 195 hp
– Torque: 260 lb-ft
2. 4.8L V8 Engine:
– Displacement: 4.8 liters
– Number of cylinders: 8
– Horsepower: 295 hp
– Torque: 305 lb-ft
3. 5.3L V8 Engine:
– Displacement: 5.3 liters
– Number of cylinders: 8
– Horsepower: 315 hp
– Torque: 338 lb-ft
4. 6.0L V8 Engine:
– Displacement: 6.0 liters
– Number of cylinders: 8
– Horsepower: 367 hp
– Torque: 375 lb-ft
5. 6.2L V8 Engine:
– Displacement: 6.2 liters
– Number of cylinders: 8
– Horsepower: 403 hp
– Torque: 417 lb-ft
Engine Oil Specs & Service Intervals
Proper maintenance of your Chevy Silverado’s engine is essential for its longevity and performance. Here are the engine oil specifications and recommended service intervals for the 2008 Chevy Silverado:
1. Engine Oil Capacity:
– 4.3L V6 Engine: 4.5 quarts (with filter)
– 4.8L V8 Engine: 6 quarts (with filter)
– 5.3L V8 Engine: 6 quarts (with filter)
– 6.0L V8 Engine: 6 quarts (with filter)
– 6.2L V8 Engine: 8 quarts (with filter)
2. Recommended Engine Oil:
– The 2008 Chevy Silverado is designed to use synthetic blend or full synthetic engine oil with a viscosity grade of 5W-30.
3. Service Intervals:
– Regular oil and filter changes are crucial for maintaining the health of your engine. For the 2008 Chevy Silverado, it is recommended to change the engine oil and filter every 7,500 miles or every 12 months, whichever comes first.
4. Oil Change Procedure:
– To change the engine oil, follow these steps:
– Park the vehicle on a level surface and engage the parking brake.
– Locate the oil drain plug underneath the engine and place a drain pan beneath it.
– Remove the drain plug and allow the old oil to drain completely.
– Replace the drain plug and tighten it to the specified torque.
– Locate the oil filter and remove it using an oil filter wrench.
– Apply a thin layer of new oil to the rubber gasket of the new oil filter.
– Install the new oil filter and tighten it by hand.
– Refill the engine with the recommended amount of new oil.
– Start the engine and check for any leaks.
– Finally, check the oil level using the dipstick and add more oil if necessary.
By following these engine oil specifications and service intervals, you can ensure that your 2008 Chevy Silverado’s engine remains in optimal condition, providing you with reliable performance for years to come. Remember to consult your vehicle’s owner manual for specific instructions and always use genuine Chevrolet parts and recommended fluids for maintenance.
0 Comments